Publicidad
Idiomas disponibles
Idiomas disponibles
USING MULTI-ZONE CONFIGURATION
This unit allows you to configure a multi-zone audio system. The Zone 2 feature allows you to set this unit to reproduce
separate input sources in the main zone and the second zone (Zone 2). You can control this unit from the second zone
using the supplied remote control.
Only analog signals are sent to the second zone. Any source you want to listen to in the second zone must be
connected to the analog AUDIO IN jacks of this unit.
Connecting Zone 2
You need the following additional equipment to use the multi-zone functions of this unit:
• An infrared signal receiver in the second zone.
• An infrared signal emitter in the main zone. This emitter transmits the infrared signals from the remote control via the
infrared signal receiver in the second zone to a CD player or a DVD player, etc. in the main zone.
• An amplifier and speakers in the second zone.
y
• Since there are many possible ways to connect and use this unit in a multi-zone configuration, we recommend that you consult with
your nearest authorized Yamaha dealer or service center about the Zone 2 connections that best meet your requirements.
• Some Yamaha models are able to connect directly to the REMOTE jacks of this unit. If you own these products, you may not need to
use an infrared signal emitter. Up to 6 Yamaha components can be connected as shown below.
REMOTE
IN
Infrared signal
receiver
■ Using the external amplifier
Connect the amplifier/receiver in the second zone and other components to this unit as follows.
DVD player (etc.)
Note
To avoid unexpected noise, DO NOT USE the Zone 2 feature with CDs encoded in DTS.
104
En
Using multi-zone configuration
REMOTE
OUT
IN
This unit
component
Main zone
This unit
Infrared signal emitter
From the REMOTE OUT jack
REMOTE
IN
OUT
Yamaha
From the ZONE 2 OUT jacks
Amplifier
Second zone
(Zone 2)
Remote control
From the REMOTE IN jack
REMOTE
OUT
Yamaha
component
Infrared signal receiver
Publicidad
