Descargar Imprimir esta página

Yamaha RX-V863 Guia De Inicio Rapido página 111

Publicidad

Idiomas disponibles

Idiomas disponibles

See page 107 for the operation of the advanced setup.
■ Remote control TUNER ID
Use this feature to set the TUNER ID of this unit for
remote control recognition.
Choices: ID1, ID2
• Select "ID1" when the remote control TUNER ID code
is set to "2602".
• Select "ID2" when the remote control TUNER ID code
is set to "2610".
Setting remote control TUNER ID codes
You need to set the remote control TUNER ID library
code for the remote control.
Set the operation mode selector to F AMP or
1
F SOURCE and then press 5 TUNER on
the remote control to select the tuner to
change the remote control ID.
Press and hold C LEARN for about 3
2
seconds using a ballpoint pen or similar
object and the 9 l / h repeatedly until
"L;TUN" and "TUNER" appear in the display
window ( 6 ) on the remote control.
LEARN
Notes
• Be sure to press and hold C LEARN for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 1.
Press 9 ENTER.
3
The four-digit code set for the selected input area
appears in the display window ( 6 ) on the remote
control.
4
Press the numeric buttons ( A ) to enter the
four-digit remote control code for the input
REMOTE TU
area you want to use.
Remote control tuner ID codes
Select one of the following codes to set the remote control
tuner ID code for the input area you want to use.
Tuner ID code
(remote control
setting)
(initial setting)
Press 9 ENTER to set the number.
5
"OK" appears in the display window ( 6 ) if setting
PRESET/CH
was successful.
"NG" appears in the display window ( 6 ) if the
setting was unsuccessful. In this case, start over from
ENTER
step 1.
A/B/C/D/E
Press C LEARN again to exit from the setup
6
mode.
LIVE/CLUB
CLASSICAL
ENTERTAIN
1
2
3
STEREO
ENHANCER
SUR. DECODE
5
6
7
MULTI CH IN
9
0
Function
2602
To operate this unit using the
default code.
2610
To operate this unit using an
alternative code.
LEARN
Advanced setup
MOVIE
4
PARAMETER
8
Remote
control
tuner ID
ID1
(initial setting)
ID2
109
En

Publicidad

loading