Yamaha RX-V863 Guia De Inicio Rapido página 46

Playback
Before performing the following operations, set the operation
mode selector on the remote control to F AMP.
Selecting audio input jacks
(AUDIO SELECT)
This unit comes with a variety of input jacks. Use this
feature (audio input jack select) to switch between input
jacks when more than one input jack is assigned to the
same input source.
y
• We recommend that you set the audio input jack select to
"AUTO" in most cases.
• You can adjust the default audio input jack select of this unit by
using "AUDIO SELECT" in "OPTION MENU" (see page 90).
Press Q AUDIO SELECT (or I AUDIO)
repeatedly to select the desired audio input jack
select setting.
Available input sources
MULTI CH VCR DVR V-AUX DTV/CBL
A.SEL: AUTO
Currently selected audio input jack select setting
AUDIO SELECT
AUTO
Automatically selects input signals in the
following order:
(1) HDMI
(2) Digital signals
(3) Analog signals
HDMI
Selects only HDMI signals. When HDMI
signals are not input, no sound is output.
COAX/OPT
Automatically selects input signals in the
following order:
(1) Digital signals input at the COAXIAL
jack
(2) Digital signals input at the OPTICAL
jack
When no signals are input, no sound is
output.
ANALOG
Selects only analog signals. If no analog
signals are input, no sound is output.
Note
This feature is not available when no digital input jacks
(OPTICAL, COAXIAL and HDMI) are assigned. In addition,
HDMI is not available as an audio input jack select setting when
the HDMI IN jacks are not used. Use "I/O ASSIGNMENT" in
"INPUT MENU" to reassign the respective input jack (see
page 85).
44
En
DVD MD/CD-R CD TUNER PHONO
Function
Displaying the current status of
this unit on a video monitor
You can display the operating information of this unit on a
video monitor.
1
Turn on the video monitor connected to this
unit.
Press L DISPLAY on the remote control.
2
The current status screen appears in the OSD.
STATUS
INPUT:
A.SEL:
[DISPLAY]:STATUS OFF
y
• You can select the amount of time that the current status is
displayed in the OSD by using the "OSD-AMP" parameter
in "OPTION MENU" (see page 88).
• To turn off the status screen, press L DISPLAY again.
Note
The OSD signal is not output at the DVR and VCR VIDEO
OUT jacks and will not be recorded.
VOL:-40.0dB
MOVIE
Sci-Fi
DVD
HDMI