Publicidad
Idiomas disponibles
Idiomas disponibles
Clearing configurations
You can clear all changes made in each function set, such
as learned functions, macros, renamed control area names
and setup remote control ID.
■ Clearing function sets
Set the operation mode selector to F AMP or
1
F SOURCE and then press C CLEAR by
using a ballpoint pen or similar object.
"CLEAR" appears in the display window ( 6 ).
AMP
SOURCE
TV
or
AMP
SOURCE
TV
Note
If you do not complete each of the following steps within 30
seconds, the clearing mode will be automatically canceled.
In this case, start over from step 1.
2
Press 9 k / n to select the clear mode.
L;CD (etc.) (L; Name of an control area)
Clears all learned functions in the respective
control area. The name of a component is
shown after a semicolon (;). Press an input
selector button to select the control area.
L;AMP
Clears all learned functions for controlling the
amplifier functions of this unit.
L;ALL
Clears all learned functions.
M;ALL
Clears all programmed macros.
RNAME
Clears all renamed source names.
FCTRY
Clears all remote functions and returns the
remote to the factory settings.
CLEAR
Press and hold C CLEAR again for about 3
3
seconds.
"WAIT" appears in the display window ( 6 ). If
clearing was successful, "C;OK" appears in the
display window ( 6 ) on the remote control.
CLEAR
y
Once you have cleared a learned function for a button, the button
reverts to the factory setting (or to the manufacturer setting, if you
have set remote control codes).
Notes
• "L;ALL" and "FCTRY" may take about 30 seconds to
complete.
• "C;NG" appears in the display window ( 6 ) if clearing was
unsuccessful. In this case start over from step 2.
• "ERROR" appears in the display window ( 6 ) if you press a
button not indicated in the respective step, or if you press more
than one button simultaneously.
Remote control features
101
En
Publicidad
