Publicidad
Idiomas disponibles
Idiomas disponibles
Customizing this unit (MANUAL SETUP)
Input rename INPUT RENAME
Use this feature to change the name of the input source
that appears in the OSD and in the front panel display.
J)DVR
INPUT RENAME
DVR .
[p]/[[]:
[ ]/[ ]:
[ENTER]:
[RETURN]:
1
Press 9 l / h to place the "_" (underscore)
under the space or the character you want to
edit.
2
Press 9 k / n to select the character you
want to use and then press 9 l / h to move
to the next space.
Notes
• You can use up to 9 characters for each input.
• Press 9 n to change the character in the following order,
or press 9 k to go in the reverse order:
A to Z, 0 to 9, a to z, symbols (#, *, –, +, etc.), space.
3
Repeat steps 1 through 2 to rename each
input source.
Press 9 ENTER to complete.
4
Volume trim VOL. TRIM
Use this feature to adjust the level of the signal input at
each jack. This feature is useful if you want to balance the
level of each input source to avoid sudden changes in
volume when switching between input sources.
Control range: –6.0 dB to +6.0 dB
Control step: 0.5 dB
Initial setting: 0.0 dB
B)TUNER
INPUT RENAME
.
VOL. TRIM;;;;+6.0dB
[ ]/[ ]:
[p]/[[]:
y
This parameter also affects the signals output at the audio ZONE
OUT jacks.
86
En
DVR
Position
Character
Enter
Return
Up/Down
Adjust
Decoder mode DECODER MODE
Use this feature to switch the decoder activation mode.
When you select "DTS" and digital audio signals are
input, this unit always activates the DTS decoder and only
plays back the DTS digital audio signals.
C)CD
I/O ASSIGNMENT
INPUT RENAME
VOL. TRIM;;;;;0.0dB
.
DECODER MODE;;;AUTO
[ ]/[ ]:
[p]/[[]:
Choice
AUTO
Automatically detects digital audio signal input
types and selects the appropriate decoder.
DTS
Activates the DTS decoder and plays back only
DTS digital audio signals when digital audio
signals are input.
Note
"DECODER MODE" is only available when the digital audio
input jacks (HDMI, OPTICAL, and/or COAXIAL) are assigned
to the selected input source.
Charge on standby STANDBY CHARGE
Use this feature to select whether this unit charges the
battery of the stationed iPod or not when this unit is in the
standby mode.
Choice
AUTO
Charges the battery of the stationed iPod when
this unit is turned on and in the standby mode.
OFF
Charges the battery of the stationed iPod only
when this unit is turned on.
Up/Down
Select
Functions
Functions
Publicidad
