Publicidad
Idiomas disponibles
Idiomas disponibles
Using multi-zone configuration
Operate the following operations after activating the Zone 2
operation mode.
Operating Zone 2
Rotate the R INPUT selector to select the
desired input source while the ZONE2 indicator
is flashing in the front panel display.
• Select "TUNER" as the input source to use the TUNER
features in Zone 2. For details about the TUNER
operations, see "FM/AM tuning" on page 53.
• Select "V-AUX" as the input source to use iPod
features or Bluetooth features in Zone 2. For details
about the iPod operations, see "Using iPod™" on
page 60 or "Using Bluetooth™ components" on
page 62.
Set Zone 2 to the standby mode
Press H ZONE 2 ON/OFF to set Zone 2 to the
standby mode.
y
Press L SYSTEM OFF to set the main zone and Zone 2 to the
standby mode simultaneously.
■ Controlling Zone 2 with the remote
control
Activating the Zone 2 operation mode
Set the operation mode selector to F AMP and
then press 6 SELECT k repeatedly to select the
Zone 2 operation mode.
"ZONE 2" is displayed in the display window ( 6 ) on the
remote control.
AMP
SOURCE
TV
y
To deactivate the Zone 2 operation mode, press 6 SELECT k / n
repeatedly to select other than "ZONE 2".
106
En
SELECT
Turning on or off Zone 2 using the remote control
E POWER and D STANDBY on the remote control
work differently depending on the selected zone that
appears in the display window ( 6 ) on the remote control.
• When the main zone, Zone 2 mode is selected, you can
turn on the main zone or Zone 2 or set them to the
standby mode individually.
• When the all mode is selected, pressing E POWER
turns on the main zone and Zone 2 simultaneously and
pressing D STANDBY sets them to the standby mode
simultaneously.
Display window
Control mode
Main zone
Name of the selected
input area
mode
Zone 2 mode
"ZONE 2" or "2;name
of the selected input
area"
All mode
"ALL"
Notes
• When the remote control is in the main zone mode, "MAIN"
appears for a few seconds when E POWER or D STANDBY
is pressed.
• "ALL" appears in the display window ( 6 ) on the remote
control only when 6 SELECT n is pressed.
Selecting the input source of Zone 2
Press one of the input selector buttons ( 5 ) to
select the input source of the selected zone.
If the remote control is used to select the input source, "2;
name of the selected input area" is displayed in the display
window ( 6 ) on the remote control when Zone 2 is
selected respectively.
Note
The selected input source is shared across all zones.
POWER
and
( 6 )
STANDBY
Turns on the main
zone only or sets it to
the standby mode.
Turns on Zone 2 or
sets it to the standby
mode.
E POWER: turns on
the main zone and
Zone 2.
D STANDBY: sets
the main zone and
Zone 2 to the standby
mode.
Publicidad
