VIRTUAL indicator
Lights up when the Virtual CINEMA DSP mode is
active (see page 51).
SILENT CINEMA indicator
Lights up when headphones are connected and a
sound field program is selected (see page 51).
G Multi-information display
Shows the name of the current sound field program and
other information when adjusting or changing settings.
H SLEEP indicator
Lights up while the sleep timer is on (see page 47).
I Radio Data System indicators
(Europe and Russia models only)
PTY HOLD
Lights up while this unit is in the PTY SEEK mode
(see page 57).
PS, PTY, RT and CT
Light up according to the available Radio Data System
information (see page 59).
EON
Lights up when the EON data service is available (see
page 58).
J Input channel and speaker indicators
LFE indicator
LFE
Presence speaker indicators
L L C R
Input channel indicators
SL SB SR
SBL
SBR
Input channel indicators
• Indicate the channel components of the current
digital input signal.
• Light up or flash according to the settings of the
speakers when this unit is in the automatic setup
procedure (see page 32) or in the "BASIC MENU"
in "MANUAL SETUP" (see page 79).
Presence speaker indicators
Light up or flash according to the setting of "EXTRA
SP ASSIGN" when this unit is in the automatic setup
procedure (see page 32) or in the "BASIC MENU" in
"MANUAL SETUP" (see page 77).
y
You can make settings for the presence and surround back
speakers automatically by running "AUTO SETUP" (see
page 32) or manually by adjusting settings for "SUR.B L/R
SP" (see page 78) in "SPEAKER SET".
Using the remote control
The remote control transmits a directional infrared ray.
Be sure to aim the remote control directly at the remote
control sensor on this unit during operation.
Approximately 6 m (20 ft)
Infrared window ( 1 )
Outputs infrared control signals. Aim this window at the
component you want to operate.
Transmit indicator ( 2 )
Flashes while the remote control is sending infrared
signals.
Display window ( 6 )
Shows the name of the selected input source that you can
control.
Operation mode selector ( F )
The function of some buttons depends on the operation
mode selector position.
AMP
Operates the amplifier function of this unit.
SOURCE
Operates the component selected with an input
selector button (see page 93).
TV
Operates the TV assigned to either DTV/CBL or
PHONO (see page 92).
Notes
• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or store the remote control in the following types
of conditions:
– places of high humidity, such as near a bath
– places of high temperatures, such as near a heater or stove
– places of extremely low temperatures
– dusty places
• To set the remote control codes for other components, see
page 94.
Connections
Remote control sensor
30
30
31
En