Querying The Prosthesis Status; Query Status Through Cockpit App; Status Display In The Cockpit App; Mymodes - Ottobock C-Leg 3C98-3 Instrucciones De Uso

→ Bluetooth is switched on for approx. 2 minutes. During this time, the app must be started
in order to establish a connection to the component.
2) Follow the on-screen instructions.
→ If Bluetooth is switched on, the

8.4 Querying the prosthesis status

8.4.1 Query status through cockpit app

1) When the component is connected, tap the symbol in the main menu.
2) In the navigation menu, tap the entry "Status".

8.4.2 Status display in the cockpit app

Menu option
Trip: 1747
Step: 1747
Batt.: 68

9 MyModes

With the help of adjustment software, the O&P professional can activate and configure MyModes
in addition to the basic mode. These can be selected by using the Cockpit app or movement pat­
terns. Switching by using movement patterns has to be activated in the adjustment software by
the O&P professional.
These modes are intended for specific motion patterns or postures (e.g. inline skating...). Set­
tings can be adjusted using the Cockpit app (see Page 71).

9.1 Switching MyModes with the cockpit app

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
establish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 71).
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see
Page 69).
Once a connection to a prosthesis has been established, the cockpit app can be used to switch
between the MyModes.
72
symbol appears on the screen.
Description
Daily step counter
Total step counter
Current prosthesis charge
level, as a percentage
Possible actions
Reset the counter by tapping
the "Reset" button.
For informational purposes
only
For informational purposes
only