APRILIA LEONARDO 125 2006 Uso Y Mantenimiento página 199

Leonardo125-300_UK.book Page 23 Monday, November 17, 2003 2:06 PM
TOOL KIT
The tool kit (1) is fixed under the saddle, inside
the crash helmet/glove compartment.
To reach it:
◆
Raise the saddle,
( U N L O C K I N G / L O C K I N G T H E
SADDLE).
The tool kit includes:
√ 4 mm hexagon spanner;
! "
√ 1 6 m m s p a r k p l u g s o c k e t
spanner;
#
√ 18 mm spark plug socket
300
spanner;
√ socket spanner rod;
√ 8/10 mm socket spanner;
√ double-ended, cross-/cut-headed
screwdriver;
√ square pin spanner;
√ tool case.
All manuals and user guides at all-guides.com
REAR MUDGUARD EXTENSION
The rear mudguard extension (2) is
provided as standard equipment and can
be installed if the vehicle is used on wet
roads, since it reduces the reach of the
see p. 22
water spray caused by the rear wheel.
NOTE
The vehicle is supplied with the
rear mudguard extension (2) already
installed in the countries where this is
required for the homologation.
F o r t h e i n s t a l l a t i o n o f t h e r e a r
m u d g u a r d e x t e n s i o n , p r o c e e d a s
follows:
◆
Raise the saddle, see p. 22 (UNLOCKING /
LOCKING THE SADDLE).
◆
Take the rear mudguard extension (2)
o u t o f t h e c r a s h h e l m e t / g l o v e
compartment together with the screws
and relevant nuts provided for the
fastening.
◆
Unscrew and remove the nuts (3).
◆
Remove the reflector (4).
◆
Unscrew and remove the nut (5).
◆
Withdraw the screw (6).
◆
Position the rear mudguard extension (2)
inside the number plate holder support
(7).
◆
Position the reflector (4) and tighten the
relevant nuts (3).
◆
Insert the screw (6) and tighten the
relevant nut (5).
◆
Make sure that the rear mudguard
extension (2) is positioned correctly.
use and maintenance Leonardo 125 - 150 - 250 - 300
23