Publicidad
Idiomas disponibles
Idiomas disponibles
Leonardo125-300_UK.book Page 61 Monday, November 17, 2003 2:06 PM
VERTICAL ADJUSTING OF THE
HEADLIGHT BEAM
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
All manuals and user guides at all-guides.com
To adjust the headlight beam:
◆
Turn the appropriate screw (1) with a
screwdriver.
By TURNING IT CLOCKWISE, you set
the beam upwards.
By TURNING IT ANTICLOCKWISE, you
set the beam downwards.
! "
HORIZONTAL ADJUSTMENT
OF THE HEADLIGHT BEAM
◆
Remove the front inner shield, see p. 54
( R E M O V I N G T H E F R O N T I N N E R
SHIELD).
★
◆
Unscrew and remove the two screws
(2).
NOTE
Depending on the adjustment to
be carried out, the screws (2) must be
replaced with longer ones (supplied in kit).
◆
Position
the
appropriate
(supplied in kit) between the headlight
fastening points and the front outer
s h i e l d , a c c o r d i n g t o t h e t y p e o f
adjustment to be carried out.
NOTE
Use fastening screws suitable for
the selected spacers.
★
◆
Insert and tighten the two screws (2).
use and maintenance Leonardo 125 - 150 - 250 - 300
4
spacers
61
Publicidad
