Publicidad
Idiomas disponibles
Idiomas disponibles
Leonardo125-300_UK.book Page 34 Monday, November 17, 2003 2:06 PM
◆
Press the start push button ≈
without accelerating and release it as
soon as the engine starts.
◆
If the engine does not start in three or
four seconds, slightly rotate the throttle
grip (8) (Pos. B), keeping the start push
2
button "
" (7) pressed.
!
CAUTION
! "
As soon as the engine has
started, the engine oil pressure warning
light "
" (5) must go out.
(
If this does not occurr, or if the warning
light comes on while the engine is
running, this means that the pressure in
the circuit is insufficient.
I n t h i s c a s e , s t o p t h e e n g i n e
immediately and contact an aprilia
Official Dealer.
Do not use the vehicle with insufficient
engine oil, in order to avoid damaging
the engine components.
use and maintenance Leonardo 125 - 150 - 250 - 300
34
All manuals and user guides at all-guides.com
2
!
∆ (7)
CAUTION
#
Do no t u nderes ti mate the
300
coming on of the engine oil change
(
warning light "
If the engine oil change warning light
(
"
" (5) comes on during the normal
operation of the engine, this means that
the engine oil must be changed as soon
as possible.
For the oil change, contact an aprilia
Official Dealer.
◆
Keep at least one brake lever pulled and
do not accelerate until you start.
!
CAUTION
Never leave abruptly with cold engine.
To reduce the emission of polluting
substances and the consumption of
fuel, warm the engine up by proceeding
at low speed for the first miles.
STARTING WITH FLOODED ENGINE
If the starting is not carried out properly or if
there is too much fuel in the intake ducts
and in the carburettor, the engine may get
flooded.
To clean a flooded engine:
◆
STARTING WITH COLD ENGINE
When the room temperature is low (near or
below 0°C), it may be difficult to start the
engine at the first attempt.
In this case:
" (5).
◆
If the engine starts.
◆
◆
Press the start push button ≈
few seconds (letting the engine spin
over) with completely open throttle (8)
(Pos. C).
Keep the start push button ≈
pressed for five seconds and at the
same time rotate the throttle grip (8)
moderately (Pos. B).
Release the throttle grip (8) (Pos. A).
If the idling is unstable, twist the throttle
grip (8) slightly and frequently.
2
∆ (7) for a
2
∆ (7)
Publicidad
