Milwaukee Allmand NIGHT-LITE PRO II Manual Del Operario página 46

47
A
Heated Fuel Water Separator Filter
The light tower unit can be equipped with an optional
heated fuel water separator filter (A, Figure 48). To drain
the water:
1. Place an approved container under the drain plug on
the fuel water separator filter.
2. Loosen the drain plug (B, Figure 48) and the air
bleeding plug (C, Figure 48) to drain the water.
3. Let the separated water drain fully into the approved
container. Dispose of water according to local, state,
province and/or federal rules.
4. Change fuel filter as needed. Refer to
Specifications.
5. Tighten the drain plug.
6. Use the pump (D, Figure 48) on the top of the fuel
water separator to prime the filter with fuel and bleed
all the air out.
7. Tighten the air bleeding plug.
48
C
46
D
A
B
www.allmand.com