Publicidad
TROUBLESHOOTING
used.
dealer to carry out repair work.
No sound.
Cannot adjust sound
volume.
(Low sound level only)
No sound when DIRECT
button is set to off.
No sound from one
speaker.
Cannot record tapes.
Cannot perform tape
copying.
The remote control unit
does not work. (Other
components cannot be
operated.)
No power supplied to unit.
e@Power plug is disconnected from the inlet and
outlet.
e The amplifier's power plug has been plugged into
another component's power outlet (e.g. timer,
etc.) but power to that unit is disconnected.
e@ POWER STANDBY/ON switch is set to STANDBY.
e Connecting cords are disconnected from jacks, or
connected incorrectly.
e Jacks, or connecting cords pin plugs are dirty.
eThe INPUT SELECTOR switch is not set to the
desired input source.
e Operation of other components is incorrect.
e@ Both SPEAKERS selector buttons are set to OFF (ML).
e MUTING button is in the on position (indicator is
lit).
e@ADPT/TAPE 3 button is in the on position.
eConnecting
cords
or speaker
cords
are
disconnected on that side.
@BALANCE control has been adjusted to one side.
@ The position of REC SELECTOR switch is incorrect.
e@ Connections are incorrect.
e Operation of cassette deck is incorrect.
@ The position of REC SELECTOR switch is incorrect.
e Operation of cassette decks is incorrect.
e Batteries are dead or no batteries in remote control
unit.
eThe remote control sensor is not receiving any
signals.
@The remote control cord is not connected.
deck.
a
e Consult the operating instructions for the cassette
decks.
eA fluorescent light is shinning on the remote sensor
window.
e Insert plug securely into the inlet and outlet.
e Turn on power to the other component.
e Press the POWER STANDBY/ON switch to ON so
that the STANDBY indicator goes off.
:
e Connect securely.
e@Clean jacks and plugs.
eSet INPUT SELECTOR switch correctly (PHONO,
TUNER, CD, LINE, TAPE 1/DAT, TAPE 2).
Consult the operating instructions for the other
components.
e Set one switch or both buttons to ON (m).
eSet
MUTING
button to the off position
(the
indicator goes off).
e Set ADPT/TAPE 3 button to the off position.
e Connect securely.
e Adjust BALANCE control to center position.
eSet switch correctly (See section "RECORDING
TAPES").
e@ Reconnect properly.
e Consult the operating instructions for the cassette
eSet switch correctly (see section "COPYING
TAPES").
elnsert
new batteries (see page 6).
e Operate the remote control unit within the range of
7 meters an angle of 30 degrees (refer to page 6).
e Connect correctly (see page 12).
e Move so fluorescent light does not shine directly
on amplifier's front panel remote sensor window.
32
<ARE7049>
En
Publicidad
