Publicidad
Idiomas disponibles
Idiomas disponibles
Notes on Operation
Do not press identical buttons on the CD player and remote control unit
simultaneously as this may cause malfunction.
The remote control unit may be difficult to operate if the remote control
sensor is exposed to strong light, such as direct sunlight or light from
fluorescent lamps, or if there are obstacles between the remote contro!
unit and the sensor.
Direct track selection
Using the track number buttons (0 ~ 9, +10), tracks can be directly
assigned for playback.
Track selection while programming
Press the program button (PROG/DIRECT) and then the track numbers
you wish to enter
into the memory.
Example:
PROG/DIRECT
~
3—- +10&1—>
5...
(Tracks
3, 11, 5 and
so on
are entered
into the
memory.)
Memorized tracks are erased by pressing the PROG/DIRECT button
(PROG/DIRECT).
ENGLISH
e
Correct
use of the track number
buttons
Direct selection of single-digit tracks is easy by just pressing the desired
track number
button.
For tracks with numbers
from
11 and on, first
press the +10 button and then a single-digit button. E.g., to select track
22, press the +10 button twice and then press the 2 button.
Volume
When a volume button is pressed, "—" appears in the minutes portion
(M) of the TIME display and the level is displayed at the seconds portion
(S) for approximately 2 seconds. The maximum level is 0, the minimum
-50. There
are 50 steps, one
step corresponding
to about
1.5 dB.
INSTALLATION PRECAUTIONS
The CD player uses a microcomputer for controlling internal electronic
circuits. In the event that the player is used while a near-by tuner or TV is
turned on, although unlikely, interference could occur either in the sound
from the tuner or the picture of the TV. To avoid this, please take the
following precautions.
TROUBLESHOOTING
Keep the CD player as far away from the tuner or TV set as possible.
Keep the power cable and connecting cable of the CD player separate
from the antenna wires of the tuner and TV.
Interference is particular likely to occur when an indoor antenna or a
300-ohm feeder cable is used. Thus, use of an outdoor antenna and
75-ohm coaxial cable is strongly recommended.
If the CD player does not seem to be functioning properly, check the
following:
Disc holder does not open or close.
e
Is the power on?
When a disc is loaded,
00220000 is displayed.
e@
Isthe disc loaded properly? ....... cece:
See page 6
When the play button ( > PLAY) is pressed, playback does not start.
e
Isthe disc dirty or scratched?
See page 11
There is no sound, or it is distorted.
e
Is the output cord properly connected to
THE AMPLIPION? scssssessssecesccctccassesscccsessvesectasvececonsesnssuasesoes See page 6
e
Have the amplifier controls been set correctly?
300-ohm
feeder cable
75-ohm
coaxial
cable
Programmed
playback does not work.
e
Have programming been properly done? ..... See pages 7 and 13
Incorrect operation when buttons on the remote control are pressed.
e
4s the remote control unit being operated
too far from the CD player? oo... seseseeeseecsereeteeeeee See page 12
e
Are there obstacles blocking the ray?
e
ls the remote control sensor exposed to strong light?
e
Are the batteries exhausted?
No data is output from the digital output jack (COAXIAL)
e
Isthe pin cord properly connected? ...........06
See Page 6.
A specific section of the disc will not play.
e
Have you changed the speed of playback? .....
See Page 11.
@
Isthe disc dirty or scratched? ........ cesses eeeeeeeree See page 11
SPECIFICATIONS
AUDIO
FUNCTIONS AND DISPLAY
No. of Channels:
2 channels
Functions:
Direct selection, automatic search,
Frequency Response:
2 ~ 20,000 Hz
programmed playback, repeat playback,
Dynamic Range:
99 dB
manual search, auto space, time mode,
Signal-to-noise Ratio:
110 dB
time edit, peak search, fader
Harmonic Distortion:
0.0025% (1 kHz)
Display:
Track number, time, music calendar,
Separation:
103 dB (1 kHz)
and engaged modes
Wow & Flutter:
Below measurable limit:
Others:
Headphones jack
(+0.001% W.peak)
REMOTE CONTROL UNIT
RC-235
Output (Analog):
2.0 V, VARIABLE 0~2.0 V
Remote Control System:
Infrared pulse system
Output (Digital):
COAXIAL (0.5 vpp 75 ohm)
Power Supply:
3 V DC; two R6P (standard size AA)
OPTICAL
dry cell batteries
DISCS
Compact Disc format
External Dimensions:
48 (1-57/64"") W x 177 (6-31/32") H x
GENERAL CHARACTERISTICS
18 (45/64")
D mm
Power Supply:
50/60 Hz, voltage is shown on rating label
Weight:
100 g {including batteries)
Power Consumption:
11W
SUPPLIED ACCESSORIES
Pin-plug connection cord
Dimensions:
434 (17-3/32") W x 110 (4-1/8") H x
280 (11-1/32")
Dmm
Weight:
4kg
* Design and specifications are subject to change without notice in the course of
product improvement.
13
Publicidad
