TOHATSU M 9.9D2 Manual Del Propietário página 25

Ocultar thumbs Ver también para M 9.9D2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Bottom of hull
2. Anti ventilation plate
ENOW00007-0
CAUTION
Before beginning the running test, check
that the boat with maximum capacity
loading floats on the water in a proper
attitude. Check the position of water
surface on the driveshaft housing. If the
water surface is near the bottom cowl-
ing, in high waves, water may enter the
engine cylinders.
Incorrect
outboard
height or existence of underwater
object(s), such as hull bottom design,
bottom surface conditions or underwa-
ter accessories, can cause water spray
possibly reaching the engine through an
opening of the bottom cowling during
cruising. Exposing the engine to such
conditions for extended periods can
lead to severe engine damage.
ENOM00830-A
Mounting bolts
Manual tilt type
1. To attach the outboard motor to the
boat, tighten the clamp screws by
turning their handles.
Also, use the bolts to secure the out-
board motor brackets on transom
board.
Secure the outboard motor with a rope
to prevent loss overboard.
1
30−50 mm
(1.2−2 in)
2
ENOF01706-0
motor
mounting
ENON00002-0
Note
A rope is not included in the standard
accessories.
3
4
2, 3
1
1. Bolt (8 × 85)
2. Nut
3. Washer
4. Clamp screw
ENON00003-0
Notes
1. Apply sealing agent, such as silicone
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 Nm (3.0 kgf) 13 ft-lb)
23
INSTALLATION
5
ENOF01707-0
5

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

M 15d2M 18e2

Tabla de contenido