Trailering - TOHATSU M 9.9D2 Manual Del Propietário

48
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENON00021-A
Note
If the outboard motor must be laid down
be sure drain the fuel, then the port side
faces down as shown in the following
drawing.
Elevate power unit 2 inches to 4 inches if
traveling to avoid oil spillage.
8
1. Handle
ENOM00072-A

3. Trailering

ENOW00072-0
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOF01738-0
1
ENOF01728-0
CAUTION
ENOW00073-A
WARNING
Be sure to disconnect fuel connector
except when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-0
WARNING
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak,
potentially catching fire.
ENOW00071-0
CAUTION
The tilt support device supplied on your
outboard motor is not intended for towing.
It is intended to support the outboard
motor while the boat is docked, beached,
etc.
When transporting a boat on a trailer with
the outboard motor still attached, discon-
nect the fuel line from the outboard motor
beforehand and keep the outboard motor
in the normal running position or on a tran-
som saver bar.
Tiller handle type
To prevent the outboard motor from mov-
ing when it is attached on a boat during
transport on a trailer, properly tighten the
steering friction bolt (page 50).
ENOF00075-1