Instructions For Use; Preliminary Checking Operations - APRILIA RS 125 Tuono 2003 Manual Del Usuario

RS 125 Tuono_Ing_book_my03.book Page 35 Tuesday, April 29, 2003 3:11 PM

INSTRUCTIONS FOR USE

Before departure, always carry
out a preliminary checking of the
vehicle to make sure that it func-
tions correctly and safely, see the fol-
lowing table (PRELIMINARY CHECKING
OPERATIONS). The non-performance of
these checking operations can cause
severe personal injuries or damages to
the vehicle.
Do not hesitate to consult your aprilia
Official Dealer in case there is some-
thing you do not understand about the
functioning of some controls or in case
you suspect or discover some irregular-
ities.
It does not take long to carry out a
check-up and this operation ensures
you much more safety.

PRELIMINARY CHECKING OPERATIONS

Component
Front and rear disc Check the functioning, the idle stroke of the control
brakes levers, the fluid level and make sure there are no leaks.
Check the wear of the pads. If necessary, top up the
fluid tank.
Accelerator Make sure that it works smoothly and that it is possible
to open and close it completely, in all steering posi-
tions. If necessary, adjust and/or lubricate it.
2 stroke oil/
Check and/or top up if necessary.
transmission oil
Wheel/tyres Check the tyre surface, the inflation pressure, wear
and tear and any damage.
Brake levers Make sure that they work smoothly. If necessary, lubri-
cate the articulations and adjust the stroke.
Steering Make sure that the steering rotates smoothly, without
any clearance or slackening.
Clutch The idle stroke at the end of the clutch lever must be
about 10÷15 mm; the clutch must operate without jerk-
ing and/or slipping.
Side stand Make sure that it works smoothly and that the spring
tension brings it back to its normal position. If neces-
sary, lubricate joints and hinges. Make sure that the
safety switch on the side stand operates correctly.
Fastening elements Make sure that the fastening elements are not loose.
If necessary, adjust or tighten them.
Drive chain Check the slack.
Fuel tank Check the fuel level and top up, if necessary. Make
sure there are no leaks or air bubbles in the circuit.
Coolant The coolant level in the expansion tank must be
included between the "MIN" and "MAX" marks.
Lights, warning lights, Check the proper functioning of the acoustic and visual
horn and electric devices.
devices Change the bulbs or intervene in case of failure.
Check Page
26, 27
28, 59
60
29, 46, 47
33
30
–
30, 31
67, 68
–
52, 53
25, 55, 73
32, 33
63÷72
use and maintenance RS 125 Tuono
35