Removing The Rider Saddle; Removing The Belly Pan Guard; Removing The Side Fairings - APRILIA RS 125 Tuono 2003 Manual Del Usuario

RS 125 Tuono_Ing_book_my03.book Page 56 Tuesday, April 29, 2003 3:11 PM

REMOVING THE RIDER SADDLE

N Position the vehicle on the stand.
N Insert the key (1) in the lock (2).
N Rotate the key (1) anticlockwise.
N Raise and remove the saddle (3).
N Remove the flap (4).
Upon reassembly:
Before lowering and locking the
saddle, make sure that you have
not left the key in the glove / tool kit
compartment.
N Position the flap (4) correctly.
Insert the rear tangs (6) of the saddle in
N
the appropriate seats (see figure).
N Position the coupling (5) in its seat, lower
and press the saddle, making the lock
snap.
Before leaving, make sure that
the saddle (3) is properly posi-
tioned and locked.
56
use and maintenance RS 125 Tuono
7
7
8
REMOVING THE BELLY
PAN GUARD
Read page 43 (MAINTENANCE) careful-
ly.
Allow for the engine and exhaust
silencer to cool down comple-
tely.
N Place the vehicle on the stand.
N Release and remove the four screws
(7).
N Remove the belly pan guard (8).
Handle plastic and paint-finished
parts with care to avoid scra-
tching or damage.
9
12
13
11

REMOVING THE SIDE FAIRINGS

Read page 43 (MAINTENANCE) careful-
ly.
Allow for the engine and exhaust
silencer to cool down comple-
tely.
N Place the vehicle on the stand.
N Release and remove the screw (9).
N Remove the front air scoop cover
(10).
N Release and remove the screw (11).
N Remove the protector (12).
10