HOME STANDBY GENERATOR- ALL aXis CONTROLLER
SPECIfICATIONS
14-kW (Model 100515) Specifications
Home Standby Generator
Maximum continuous power, LPG
Maximum continuous power, NG
Rated voltage
Amps
Harmonic distortion
Main line circuit breaker
Phase
Frequency
Unit weight
Size (L x W x H)
Engine
Type
No. of cylinders
Displacement
Cylinder block
Ignition system
Spark plug
Governor
Starter
Oil capacity
Oil Type
RPM
Controls
Mode switch auto
Mode switch manual
Mode switch off
Ready to run/maintenance messages
Programmable start delay
Engine start sequence
Starter lockout
Battery charger/low battery indicator
Charger fault
AVR over voltage protection
Low oil protection
Safety fused
Overcrank/overspeed/underspeed protection
* Serial Number Y2212150069+: Unit comes with oil pre-filled in unit.
Serial Number < Y2212150069: Unit does not come with oil. You must ADD OIL before starting the unit.
After 5 hours, change oil per maintenance schedule. The recommended oil type for typical use is 5W-30 full synthetic oil. However, using the listed conventional oils shown
in the "Recommended Engine Oil Type" chart may be used for typical use. If running generator in extreme temperatures, refer to the "Recommended Engine Oil Type" chart.
MODELS
®
14 kW
12.5 kW
120/240
116.6/58.3 LPG (propane), 104/52 NG (natural gas)
Less than 5%
65 amp
Single
60 Hz
438.7 lb. (199 kg)
49 x 28 x 28 in. (124.5 x 71 x 71 cm)
Milwaukee Series OHV Commercial V-Twin
2
754 cc
Aluminum with cast iron sleeves
Solid state – magneto
F7RTC (NGK BPR7ES)
Mechanical
Electric 24V DC
1.6 qt (1.5 L)
5W-30 Full Synthetic*
3600
Auto start on utility failure
Starts on demand
Stops unit/control and charger active
Standard
Standard
Standard
Standard
Standard
Standard
Standard
Standard
Standard
Standard
14
SPECIfICATIONS