Champion Global Power Equipment 100304 Manual De Instalación página 36

HOME STANDBY GENERATOR- ALL aXis CONTROLLER
Wire Land
Function
Points
Position #4 Not connected
Position #5 High engine temperature
Position #6 Low oil level/pressure
Position #7 Not connected
Position #8 Fuel supply valve
Position #9 Starter
Position #10 Stop
Position #11 B+
Position #12 B-
BOTTOM ROW
There are 12 wire land points in the bottom row, 8 are the same
size, the remaining 4 points are larger, viewed left to right.
100417
The following are the wire land points, function and wire color,
viewed left to right.
Wire Land
Function
Points
Position #1 Frequency
Position #2 Frequency
Position #3 Not connected
Position #4 Not connected
Position #5 High Engine Temperature
Position #6 Low oil level/pressure
Position #7 Not connected
Position #8 Fuel supply valve
Position #9 Starter
Position #10 Stop
Position #11 B+
Position #12 B-
Exterior Warning LED
The exterior of the generator enclosure includes a Warning LED
that illuminates RED when a fault has occurred
The Warning LED provides a visual indicator to homeowners
and service technicians that a fault has occurred, and service is
needed.
The warning LED is located on the back-exterior of the HSB.
MODELS
®
Wire Color
Empty
BR (brown)
Y (yellow)
Empty
G/B (green/black)
B/W (black/white)
L/B (blue/black)
W (white)
G (green)
Generator ON/Off Switch
If maintenance or service work is going to be performed on the
generator or the home's electrical system, accidental startup
Wire Color
is further safeguarded by pulling out the fuse from the aXis
R (red)
controller panel and disconnecting the batteries.
B (black)
Empty
14-kW (MODEL 100515)
Empty
This generator has an ON/OFF switch that when turned off, will
BR (brown)
shut down the HSB (if running) and deactivate the aXis controller
Y (yellow)
preventing future starts. This switch should be used in instances
Empty
where the HSB needs to stay off regardless of utility power
G/B (green/black)
presence. When the switch is in the OFF position, the HSB will not
B/W (black/white) exercise or start for any reason.
L/B (blue/black)
When the switch is in the ON position, the aXis controller will be
W (white) energized and the HSB will be controlled by the programming of
the aXis controller. The switch needs to be in the ON position in
G (green)
order for the HSB to be in AUTO mode.
36
INSTALLATION
14-kW (Model 100515)
22-kW (Model 100304)
NOTICE

ON
OFF