Home Standby
Generator Settings
HOME STANDBY GENERATOR- ALL aXis CONTROLLER
Generator Date and Time
6. Some operating systems will require additional steps to
confirm update, accept all pop-up windows until progress bar
Date
is seen on screen.
Time
Are your sure to save the changes?
Day Light Saving
EDIT DATE & TIME
Generator Exercise
(Automated Maintenance Running)
Saving...
Frequency:
Day:
Time:
EDIT EXERCISE FREQUENCY
7. Set the HSB exercise frequency and schedule.
Generator Exercise
(Automated Maintenance Running)
Freq:
Day:
Time:
CONFIRM EXERCISE FREQUENCY
MODELS
®
March 22, 2022
Unsaved Changes
08:40 AM
Unsaved Changes
On
Unsaved Changes
Cancel
OK
Every Week
Friday
09:00 AM
Choose Mode...
Choose Day...
Choose Hour...
Choose Minute...
Choose AM/PM...
Are your sure to save the changes?
8. Confirm and apply the settings before continuing. Unsaved
changes are highlighted.
Generator Exercise
(Automated Maintenance Running)
Generator Exercise
(Automated Maintenance Running)
Are your sure to save the changes?
9. Wireless network settings are not used at this time. The
default values (shown below) should not be adjusted.
Adjustment of this factory settings will require a certified
electrician to correct.
Wireless Network
Cancel
OK
10. The time, date, and exercise information have now been
setup for the aXis ATS and HSB. You can close your browser
and disconnect from the ATS Wi-Fi, or skip to step 2 in the
next section "ATS and HSB STATUS USING WI-FI"
42
Frequency
Every Week
Unsaved Changes
Day
Thursday
Unsaved Changes
Time
01:00 PM
Unsaved Changes
EDIT EXERCISE FREQUENCY
APPLY
Frequency
Every Week
Unsaved Changes
Day
Thursday
Unsaved Changes
Time
01:00 PM
Unsaved Changes
EDIT EXERCISE FREQUENCY
Internet Service:
Direct Connect
Web Page Mode:
AP Mode
AP Mode IP : 192. 168. 0. 90
CONFIRM NETWORK SETTINGS
CANCEL SETTINGS
INSTALLATION
REVERT
Cancel
OK