Champion Global Power Equipment 100304 Manual De Instalación página 52

HOME STANDBY GENERATOR- ALL aXis CONTROLLER
No AC output
7 Poor wiring connections*
8 ATS problems*
LED Indicators
In all cases when the GREEN icons are lit, this is an indicator that the HSB is performing properly.
In all cases when the RED icons are lit, this is an indicator that the HSB has registered a fault and must be corrected. Only the "LOW
BATTERY" and "MAINTENANCE" icons will not latch out or shut down the HSB. All other RED icon faults will latch out, shut down, disable
starting and light the RED icons on the aXis Controller and the exterior warning LED on the backside of the HSB.
Reset fault code(s)
There is an exterior warning LED located on the back of the enclosure. This should be checked weekly to make sure there are no active
fault codes.
The fault code(s) can be reset by placing the aXis Controller in the OFF position for 10 seconds and then placed into ATS mode. This will
reset fault icon, however if a fault code(s) re-occurs it must be addressed.
BATTERY(S) NO OR LOW LEVEL CHARGED, BATTERY(S) DEAD, NEEDS REPLACEMENT, THE EXERCISE TIME MUST BE RESET ONCE
THE BATTERY(S) HAVE BEEN DISCONNECTED.
* *Contact Champion Power Equipment, Technical Service toll free 1-877-338-0999, tech@championpowerequipment.com or your nearest Champion dealer.
www.championpowerequipment.com
MODELS
®
52
TROUBLESHOOTING HSB