STAMOS S-LS-118 Manual De Instrucciones página 28

Menu keys:
STATIC (F1)
OCP/OPP (F2)
BATTERY (F3)
USB(F4)
DYNAMIC(FS)
CONFIG(F6)
Keyboard function:
ESC key for escape and delete
F1 to F6 Function keys
TAB Change focus
1. Pause during waveform display
STOP
2. Long press to take a screenshot
LOCK Long press to lock the keyboard, and long press again to unlock it
1. Short press to enter CC mode
CC
2. Long press SHORT
CV Enter CV mode
ew Enter CW mode
CR Enter CR mode
1. Short press the number keys
2. Long press numeric 1 to 6 to call static storage units 1 to 6
3. Long press 7 to set RTC, and long press aga in to save and exit
0 to 9
4. Long press 8 set LCD backlight, and long press again to save and exit
5. Long press 9 to enable the USB storage, and long press again to turn off the storage
6. In the main interface, long press numeric 0 for more than 3s to calibrate 0
Press TAB to select voltage or current, and press WAVE to display 4 measurement lines,
among which 2 vertical lines measure time, and 2 horizontal lines measure voltage and
current amplitude respectively.
1. Short press ← (left key) to select the vertical line on the left
2. Short press → (right key) to select the vertical line on the right, and long press after
WAVE STOP to move the waveform to the right
3. Short press ↑ (up key) to select the measured voltage amplitude, and long press to
modify the voltage scale value
4. Short press ↓ (down key) to select the measured current amplitude, and long press
to modify the current scale value
5. Enter to adjust the sampling time value
ON Turn on and turn off
1. Short press to enter
Enter
2. Long press to save
Note: The long press time is about 1.5s
3.2. Static mode
3.2.1. Static CC
In constant current mode, the load consumes a constant current regardless of whether the input voltage is
changed.
Operations:
1) Press CC or the soft key Fl on the keyboard.
Enter static CC, CV, CW CR, or SHORT
call tables OCP and OPP
Battery measurement made: VI curve
The panel will display the USB logo after inserting the U disk, and it will display blank
when it is not inserted. Save data to U disk, import and export LIST to U disk.
Dynamic CC, CV, CW, CR, RL, or PL
Parameter settings