STAMOS S-LS-118 Manual De Instrucciones página 33

Press left and right keys (← and →) to the second item SLOPE (A/μS), edit the value as 0.001A/uS, and
press ENTER, and the background will be switched to blue. Press left and right keys (← and →) to the third
item TIME (S), edit the value as 1s, and press ENTER.
6) Repeat the above steps to start setting the second and third rows of the table.
7) Long press ENTER to save the edited data.
8) Press the soft key (F3) LIST/CALL to display CALL.
9) Press ENTER to call LIST1.
10) Turn ON/OFF.
Note:
To delete data after Row 3, select Row 4 in LIST SAVE made.
Press ENTER to enter the editing background and it turns red, and then press ESC to delete all data after
Row 4. Long press ENTER to save the data.
Fig. 4.1 LIST
3.5. Battery Test Mode
A maximum of 7 groups of battery test parameters can be set, the battery is tested according to the set
current, voltage, capacity, time, and the test is automatically turned off if one of the conditions is met.
3.5.1. Battery test setup
Operation instructions: it takes the settings stored in Group 1, the current range of 10A, the discharge
current of 1A, the discharge cut-off voltage of 2V, the discharge cut-off capacity of 0.5Ah, and the
discharge duration of 200m (battery time unit: m) as an example
1) Press (F3) Battery on the main interface to enter battery measurement.
2) Press (F1) BATT/CALL, and press TAB to select CALL GROUP 1.
3) Press (F2) BATT/SAVE to display SAVE on the table.
4) Press TAB to switch the focus and turn the knob to select the row position that needs to be modified.
5) Press ENTER to select the red background.
6) Enter numeric 0 to 9, and ESC.
7) After editing the range of 10A, press ENTER. Then 10.000 will be displayed on the screen, and the
background will be switched to blue
8) Repeat the above steps to set 1A, 2V, 0.5Ah, and 200m respectively.
9) Long press ENTER to save the edited data.
10) Press (F1) BATT/CALL.
11) Press ENTER to call.
12) Turn ON/OFF.