Bianchi E-OMNIA FX Manual Del Usuario página 6

HEAD SET AND HANDLEBAR STEM AND BEND
The product uses a head set system manufactured by FSA. Both bearing diameters are 1½".
The handlebar stem supplied with the products is compatible with 1 ⅛" forks (seat posts measuring 28.6 mm in diameter) and handlebar
bends measuring 35 mm in diameter for the e-Omnia FX-Type product and handlebar bends measuring 31.8 mm in diameter for the e-Omnia
X-Type, e-Omnia T-Type and e-Omnia C-Type products.
The height of this type of handlebar stem can be adjusted by a specialist retailer. Due to the importance and complexity of this component,
please consult your retailer for handlebar stem adjustment and to fully understand the mechanisms and adjustment methods.
DANGER!
Always comply with the torque values specified on the handlebar stem. Incorrect tightening may cause the component to malfunction
or break, causing the rider to lose control and fall!
Never use this product with incomplete or incorrect assembly. This endangers not only the rider but also other road users.
The gear/brake control levers are mounted on the handlebar using a clamp integrated into the components. Consult the specific component
handbook provided by the manufacturer for the correct torque.
WARNING!
Turn the handlebar left and right. Do not use the bike if there is any evidence of abnormal steering (play in the steering or uneven
resistance) or if any cracks or signs of damage are evident.
In the event of an accident or fall, the handlebar will almost certainly be involved and will be subjected to high levels of stress and impact.
In the event of any deep scratches or cracks, replace the components.
WARNING!
If the handlebar is damaged, stop using the bike immediately.
Do not use the bike until a specialist retailer has conducted a full inspection and, if necessary, the handlebar has been replaced.
THRU-AXLES
WARNING!
Use caution and observe the following warnings. Failure to comply with the warnings and provisions contained in this data
sheet exempts the manufacturer from any liability.
6
INFORMATION!
New and innovative components and features are being
developed all the time.
To check compatibility with drive units other than those originally
installed on the Bianchi frame or to receive information and
instructions on specific components that may be required to install
a product or upgrade one, please contact your preferred Bianchi
retailer.