Bianchi E-OMNIA FX Manual Del Usuario página 9

DANGER!
Exceeding the limit may cause the component to malfunction or break, causing the rider to lose control and fall
BATTERY COVER AND REMOVAL
e-Omnia FX-Type, e-Omnia X-Type, e-Omnia T-Type
To assemble the battery cover, push the upper part of the cover to set it into the frame (image 1F). Then push the lower part of the cover
to engage the snap (image 1G).
To remove the battery cover, pull the bottom carefully and lift the cover off.
1F
e-Omnia C-Type
To assemble the battery cover, insert 'the latch' on the cover (image 1H, 2H) into the holder on the frame. Then push the button in the lower
part of the cover to engage the snap (image 1K). The button should not be pressed in the middle, but should be pressed on the outer section
with at least two fingers.
To remove the battery cover, press the button in the center, lift the cover carefully and slide it off the latch on the cover.
1H
1E
WARNING!
When removing the seat post never exceed the safety limit indicated on the component. (image 1E)
2H
1G
1K
9