Rowlett CX116 Manual De Instrucciones página 11

Using the provided digital
scale
Z/T
ON/OFF
Note:
• This device is not government stamped, and as
such is unsuitable for use as retail food scales.
• The accuracy of this device has been tested
as part of the manufacturing quality control
process.
Features
• Zero and tare function
• Auto shut-off
• Maximum load capacity: 3kg
• Overload indication: EEEE
• Convertible between metric and imperial unit
systems with "UNIT" button
To install or replace batteries
• Remove the battery compartment cover (on
the bottom of the device).
• Insert 2 x 1.5V AAA batteries (not supplied),
and ensure to follow polarity markings on the
battery compartment. Re-locate the battery
compartment cover.
• Position the device on a flat stable surface.
(Note: It is important that the scale is level to
ensure accuracy.)
To start weighing
• Place a bowl (if necessary) on the scale
• Press "ON/OFF" to turn on. Wait until the LCD
shows "0".
• Load ingredients in the bowl to start weighing.
LCD will show the weight value.
• Press "UNIT" button to convert the weight unit.
CX116_ML_A5_v1_20231012.indb 11 CX116_ML_A5_v1_20231012.indb 11
"ZERO" or "TARE" function
To weigh different loads consecutively without
removing previous loads from the scale:
1. Put first Load on the scale and get weight
reading.
HOLD
2. Press "Z/T" button to reset the reading to "0"
before adding next load. You can repeat this
operation.
UNIT
Condition 1: "ZERO" function
When total sum of all loads on scale is ≤4% of
scale's maximum weight capacity (4% here means
120g with this scale), display will show "0 g" each
time "Z/T" button is pressed.
Condition 2: "TARE" function
When total sum of all loads on scale is >4% of
scale's maximum weight capacity (4% here means
120g with this scale), display will show "0 g" each
time "Z/T" button is pressed. Meanwhile an icon
"TARE" on the display indicate TARE function is
activated.
Under this condition:
• By pressing "Z/T", you can see the total weight
of all loads on the scale.
"HOLD" function
• Press "HOLD" button while in weighing mode.
An icon "HOLD" will be shown.
• The weight value will keep unchanged no
matter the actual weight has changed or not.
• Press "HOLD" button again to exit. The icon
"HOLD" will disappear and the actual weight
value will be shown.
Shut off
Auto shut-off: Auto shut-off occurs if display
shows '0' or shows the same weight reading for
5 minutes.
Manual shut-off: To maximize battery life, always
press "ON/OFF" to turn off the scale after use.
Cleaning and Care
• Clean the surface with a damp cloth. Never
immerse in water or use chemical/abrasive
cleaning agents.
• Remove the batteries if the unit is not to be
used for an extended period of time.
EN
11
2023/10/12 13:17 2023/10/12 13:17