Publicidad
Idiomas disponibles
Idiomas disponibles
When lifting saw, hold it close to your body. KEEP knees bent and lift with your legs, not your back. Fully assemble Saw
with Stand Assembly prior to use. Stand Assembly is an integral and necessary part of the support structure for this Saw. DO NOT attempt
to substitute a table or other surface for the Stand Assembly. DO NOT modify saw, or create accessories not recommended for use with
this Saw. DO NOT connect to power supply until assembly is complete. Make sure power switch is in "OFF" position before connecting to
power supply. Avoid contact with Blade Teeth. KEEP Blade stored or lowered when possible.
ASSEMBLING THE STAND
Note: Stand only applicable for 36-6013 X models. 36-6013 models
see page 15.
1.
Assemble Stand Part 2
has the cross support as shown in Figure 1.
2.
Using the supplied 4mm Combination Allen Wrench
and 13mm Combination Wrench (Not Supplied), secure
Stand Assembly with M8 x 65mm Hex Socket Head Screw
, M8 Plastic Spacer
HP4
1.5T
, and M8 Lock Nut
HP2
for other side.
3.
All four holes should face up to mount saw body. See
Figure 3 for correct stand parts setup.
NOTE: M8 Plastic Spacer
Stand Part 2
.
PC12
4.
Turn stand upside down to attach legs. With assembled
stand open, with the 13mm Combination Wrench (Not
Supplied), attach (4) Stand Legs
M8 x 30mm (1 3/16 inch) Carriage Bolts
lock nuts
. Tighten lock nuts to secure legs to stand, as
HP5
seen in Figure 4.
NOTE: DO NOT over tighten lock nuts.
See finished assembly of stand in Figure 4.
ASSEMBLY
through Stand Part 1
PC12
, 2 Flat Washer 8mm x 14mm x
HP3
. See Figure 2. Repeat this
HP5
is between Stand Part 1
HP3
to the stand using (8)
PC13
and (8) M8
HP1
that
PC11
PC12
HP9
HP9
and
PC11
PC11
CORRECT
13
FIGURE 1
HP4
HP2
HP3
FIGURE 2
HOLES FACING UP
PC12
PC11
INCORRECT
FIGURE 3
PC13
HP5
HP1
FIGURE 4
PC11
HP5
HP2
PC12
Publicidad
