Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING BLADE PARALLEL TO
MITER GAUGE GROOVE (HEEL)
•
Blade
MUST be parallel to miter gauge groove so that
A
wood does not bind, resulting in kickback. Failure to do so
could result in serious personal injury.
•
To reduce risk of injury from kickback, align miter gauge
groove to blade
following any blade adjustments.
A
DO NOT loosen any screws for this adjustment until alignment has
been checked with a square to be sure adjustments are necessary.
Once screws are loosened, items MUST be reset.
NOTE: Unplug saw. Remove blade guard and anti-kickback pawls.
Raise the blade
to maximum height by turning height adjusting
A
wheel.
1.
Mark beside one of blade teeth at front of blade
22. Place the combination square against the marked tooth
at the front of the blade
against the miter gauge groove as shown.
2.
Turn blade
so that marked tooth (1) is at back. Move
A
combination square to the rear and again measure the
distance (2). If the distances are the same, blade
parallel. See Figure 23.
If the distances are different:
3.
Using a 5mm Hex Wrench loosen the front trunnion bolts
1/2 turn, found below the table top. See Figure 24.
MAKING ADJUSTMENTS
Figure
A
with the head of the square
A
A
1
is
A
1
1
20
A
2
FIGURE 22
2
FIGURE 23
FIGURE 24
Publicidad
