Delta 36-6013 Manual De Instrucciones página 17

ANTI-KICKBACK PAWLS AND BLADE GUARD
ANTI-KICKBACK PAWLS
To reduce the risk of serious personal injury,
Anti-Kickback Pawls MUST be in place when making a
PC6
through cut.
1.
Refer to Figure 13 and locate the Anti-Kickback Pawls
Mounting Slot in the middle of the top edge of the Riving
Knife .
A
2.
Slide slot in the middle of the Anti-Kickback Pawls
Assembly along the top of the Riving Knife
PC6
the Press Pin locates the center slot on the Riving
B
Knife .
A
3.
Depress the Press Pin
Assembly to allow the Assembly to drop into the slot.
PC6
Push down on the Anti-Kickback Pawls Assembly
it snaps into place and locks. Release Push Pin
NOTE: Pull up on the Anti-Kickback Pawls
locked in place.
4.
To remove the Anti-Kickback Pawls
Pin and pull the Anti-Kickback Pawls Assembly
B
the Riving Knife .
A
BLADE GUARD
To reduce the risk of serious personal injury, the
Blade Guard MUST be in place when making a through cut.
1.
Before installing the Blade Guard Assembly, make sure the
riving knife is raised to the thru-cut position. While holding
the Blade Guard Assembly
the Locating Pin
C
Assembly into the slot at the back edge of the Riving Knife.
See Figure 14.
2.
Rotate the Blade Guard Assembly toward the front of the
Saw until the Support Arms
Assembly are parallel to the Table see Figure 15.
3.
See Figure 16 (next page). While holding down on the
front of the support arms
Guard Lock Tab
A
position. Check to make sure the Guard is locked onto the
Riving Knife by pulling on the Guard. If the Guard is not
locked, the Blade Guard Lock Tab
unlocked position.
If the Support Arm
Assembly is not parallel to the Table, the Riving Knife is not in the
raised (through cut) position. Remove Blade Guard Assembly and
Anti-Kickback pawls and raise Riving Knife, then reinstall the Anti-
Kickback pawls and the Blade Guard Assembly.
4.
Raise and lower each side of the Blade Guard to verify free
movement of the Guard System. Be sure the Guard System
can be raised enough to clear your workpiece.
NOTE: Blade alignment with Riving Knife can be adjusted. See:
"RIVING KNIFE POSITION AND ALIGNMENT", page 27. Check the
Blade Guard for clearances and free movement.
ASSEMBLY
on the Anti-Kickback Pawls
B
B
to make sure it is
PC6
, depress the Press
PC6
in a vertical position, hook
PC5
at the back end of the Blade Guard
of the Blade Guard
D
of the Guard press the Blade
B
down until it snaps into the locked
will flip up to the
A
of the Blade Guard
D
PC6
until
A
until
PC6
.
off
PC6
17
PC6
B
FIGURE 13
FIGURE 14
FIGURE 15
A
D
PC5
C