Delta 36-6013 Manual De Instrucciones página 14

ATTACHING STAND TO SAW
1.
Place Saw Body
PC1
screw holes in the Saw Stand with the threaded holes in
the Saw Base. See Figure 5.
2.
Tighten (4) M8 x 55mm Pan Head Hex Socket Screws
with supplied Combination 4mm Allen Wrench
secure Stand Assembly to Saw.
NOTE: DO NOT over tighten. Hex wrench storage provided on
saw near fence storage bracket.
ASSEMBLY
on Stand Assembly, while aligning the
,
HP6
to
HP9
14
PC1
FIGURE 5