Delta 36-6013 Manual De Instrucciones página 23

ADJUSTING THE BLADE HEIGHT
1.
For all through cuts, the top of the blade points should be
above the workpiece and the bottom of the blade gullets
are below the top surface of workpiece.
2.
For non-through cuts, the top of the blade points should be
set to the depth of the cut.
To adjust the height of the blade, see Figure 30 and do the following:
3.
Make sure the bevel locking lever
position.
4.
Adjust the blade height by turning the Height Adjustment
Handwheel. Clockwise will raise the blade and
counterclockwise lowers it.
CHANGING THE BEVEL
See Figure 30.
1.
Unlock the bevel locking lever
unlock position.
2.
Holding knob/wheel
desired angle.
3.
When the blade is at desired angle, lock the bevel locking
lever by pushing it down to the lock position.
B
ADJUSTING RAIL SYSTEM
To reduce the risk of injury, ALWAYS make sure the rip fence is
parallel to the blade before beginning any operation.
1.
Lift extension lock lever
2.
Slide fence in or out until the desired cutting dimension is
achieved.
3.
Push extension lock lever
lock.
MAKING ADJUSTMENTS
is in the locked
B
by pulling it into the
B
, slide the handwheel to the
A
to unlock position.
C
lock down to engage the
C
B
C
C
23
UNLOCK UNLOCK
LOCK LOCK
FIGURE 30
Unlock Unlock
Lock Lock
FIGURE 31