Publicidad
Idiomas disponibles
Idiomas disponibles
HEIGHT ADJUSTMENT KNOB
INSTALLATION
1.
Insert Handwheel Knob Shoulder Screw
Adjustment Knob
HP8
2.
Tighten Shoulder Screw with Combination 4mm Allen
Wrench/Phillips Screwdriver
into the Hand Wheel. Height adjustment Wheel Knob
should rotate freely around Shoulder Screw when raising or
lowering the Blade with the Height Adjustment Handwheel.
INSTALLING THE BLADE
1.
Raise Motor/Arbor Assembly to the upper most position to
provide easy access to Riving Knife Lock Lever and Arbor
Assembly.
2.
Ensure Riving Knife Lock Lever is in unlock position. See
Figure 7.
3.
Detach the On-Board Wrenches located on the Right
Side of the Saw behind blade guard storage in Figure 20
by loosening and removing M8 Wing Nut.
A
4.
Place the Open-Ended Wrench
between the Arbor Flange and the Inner Blade Washer.
Place the Closed End Wrench
5.
Holding the Spindle Shaft in place, loosen and remove the
Arbor Nut and Outer Blade Washer. See Figure 7.
NOTE: Use ONLY 10 inch (254mm) diameter Blades with 5/8
inch (16mm) arbor holes, rated at 5,000 rpm or higher, 0.10 inch
(2.6mm) min. kerf width and 0.073 inches (1.85mm) max body
thickness. ONLY use 10 inch blades designed for woodcutting.
6.
Place Blade
on the Arbor Shaft
PC3
the Blade pointing toward the front of the saw. Place
Outer-Blade Washer
side of the Washer against the Blade, then secure Blade
Assembly with Nut
C
7.
Tighten Nut with Blade Wrenches
Wrench will fit on the Arbor Shaft between the Inner
Flange Washer
and the Motor Assembly (if necessary,
D
turn Arbor Shaft to align Flats on the Arbor Shaft to the
Wrench). Closed End Wrench will fit on the Nut. See Figure
9.
8.
Return Wrenches
location and secure the M8 Wing Nut. Position the Riving
Knife in the through cut position prior to installation of
Throat Plate. See Figure 10.
Details for positioning the Riving Knife are on page 27 "RIVING
KNIFE POSITION AND ALIGNMENT".
ASSEMBLY
into Height
HP7
as shown in Figure 6.
or Phillips Screw Driver
HP9
on the Spindle Shaft
PC8
over the Arbor Nut.
PC9
with the teeth on
B
on the Arbor Shaft with the large
A
. See Figure 8.
and
. Open End
PC8
PC9
and
to On-Board Storage
PC8
PC9
HP7
HP8
PC9
PC8
TOOTH
DIRECTION
FRONT
OF SAW
PC9
PC8
15
FIGURE 6
UNLOCK
POSITION
FIGURE 7
PC3
D
FIGURE 8
FIGURE 9
A
C
B
Publicidad
