Delta 36-6013 Manual De Instrucciones página 21

4.
Using a 5mm Hex Wrench loosen the rear trunnion bolts
1/2 turn, found below the table top. See Figure 25.
5.
If the rear of the blade was too close to combination
square, place a block of wood on the right side of the
blade. Lightly tap with a small hammer or rubber mallet to
achieve the correct parallelism adjustment. See Figure 26.
6.
Re-tighten the trunnion bolts with 5mm Hex Wrench.
Re-check alignment after bolts are re-tightened.
SQUARING THE BLADE
VERTICALLY TO THE TABLE
1.
Place a combination square
side of the blade, avoiding contact with the teeth. See
Figure 27.
2.
If it is not square, adjust the 0° stop as shown in
"Adjusting The Bevel Stops".
MAKING ADJUSTMENTS
against the table and the
B
21
FIGURE 25
FIGURE 26
FIGURE 27
B