Delta 36-6013 Manual De Instrucciones página 26

RIVING KNIFE POSITION AND ALIGNMENT
RIVING KNIFE HEIGHT SETTINGS
See Figure 38.
The height of the riving knife should be adjusted based on the
type of cut being made. For all through cuts (when the wood is
completely severed), it should be in the raised position, with anti-
kick pawls and guard installed. For non-through cuts (when the
blade does not penetrate the top of the workpiece), the riving knife
should be in the lowered position and anti-kick pawls and guard
removed.
TO RAISE OR LOWER THE RIVING KNIFE:
1.
Remove the blade guard, anti-kickback pawls, and throat
plate and raise blade to the full height above the table.
2.
Locate the locking lever
knife.
3.
Rotate the lever
A
release the riving knife from its locked position.
4.
Using your hand positioned near the top of the knife, lean
the knife outward away from the two locking pins beside
its middle slot. This now frees the knife to slide into the
upward/cut through position.
5.
Lift the knife upward along the slot until you feel the new
locking pins position.
6.
Release the knife and it should snap into its new position;
wiggle if necessary.
7.
Return the locking lever
have done this properly the riving knife will be aligned with
the blade. If it is not retrace your steps until it does. The
appropriate marking will be seen at the table top level.
NOTE: When adjusting the riving knife up or down, be sure
to pull in a radial motion, as shown.
DO NOT operate saw unless riving knife is
securely clamped in the raised position for through cutting or
the lowered position for non-through cutting, unless Riving Knife
would interfere with the cut.
NEVER use a blade that does not match the
dimensions indicated for use with your riving knife.
near the base of the riving
A
by turning clockwise to unlock and
to the locked position. If you
A
Adjust
Locked Locked
26
Pull Away
to Release Riving Knife
Lower Lower
Position Position
Detents Detents
A
Upper Position Upper Position
Detents on Pins Detents on Pins
FIGURE 38