cecotec BOLERO COOLMARKET 4D 490 INOX E Manual De Instrucciones página 68

ENGLISH
- Place the refrigerator and adjust its height, clean it, let it rest for 4 to 6 hours, and switch
it on. This will help ensuring that the compressor oil has properly settled, and that the
appliance is running normally.
3. OPERATION
Installation size. Fig. 3
Select an appropriate level-surfaced location to place your appliance for easy use. Avoid
placing the appliance near heat sources, under direct sunlight, or in moist environments.
A (mm) B (mm)
551 911
The above values are indicative for installation purposes. Actual sizes may vary slightly.
To ensure that the appliance runs at maximum efficiency, allow enough space around the
appliance as shown in Figure 4.
Start-up
- Connect the power cord and turn on the switch.
- On first use, the display will show the respective default temperature values (refrigerator
compartment is set to 5 °C, freezer compartment to -18 °C).
- The default mode is the power-saving mode, with the display timeout time being 20
seconds. This mode saves energy and increases the lifespan of the LED lights.
Automatic defrosting
The appliance is equipped with a programme that controls the frequency and duration of
freezer defrosting. This allows for the freezer to defrost automatically, sparing you the
trouble.
LED display and temperature control
The display shows the temperature of the refrigerator compartment and the freezer
compartment respectively. To change the setting in either of the two compartments, simply
press the up or down arrow depending on the change you wish to make.
Removable and easy-to-clean door seal
The door seals are easy to remove and clean, allowing for efficient, long-lasting operation.
Carrying
- Do not carry the refrigerator horizontally or lying down.
68
BOLERO COOLMARKET 4D 490 INOX E/ DARK E/ GLASS E
C (mm) D (mm)
1774 1830
E (mm) F (mm)
636 1661
Height (mm) M (mm)
393 1018