Descargar Imprimir esta página

cecotec BOLERO COOLMARKET 4D 490 INOX E Manual De Instrucciones página 69

Ocultar thumbs Ver también para BOLERO COOLMARKET 4D 490 INOX E:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 52
-
Do not carry the refrigerator by the door or handle; carry the refrigerator by lifting from
the bottom.
Never carry the appliance alone–at least two people are required for safe lifting or carrying
of the appliance. (Fig. 5)
Installation location
-
The refrigerator must be placed on a solid, flat surface.
-
If cushioning is necessary, use stable, solid, and non-flammable cushioning blocks.
-
DO NOT USE FOAM PACKAGING AS CUSHIONING BLOCKS!
-
The appliance should be kept away from damp or wet environments. Water or dirt should
be removed from any surface of the appliance as soon as possible with a soft cloth. This
will help prevent rust and help your appliance run at maximum efficiency.
Place the refrigerator in a well-ventilated place, reserve some space around and behind the
refrigerator, and do not cover or block the air grille of the compressor rear cover plate at the
back of the refrigerator. Keep the refrigerator away from heat sources or direct sunlight.
Adjustable feet Fig. 6.
-
In the refrigerator packing box, feet come tightly packed. After removing the refrigerator
from the box for installation, be sure to adjust the two front feet to the desired height;
adjust the two feet with a spanner or directly by hand.
-
The feet and rear rollers must touch the floor to prevent the refrigerator from moving,
vibrating, or rattling.
-
When moving the refrigerator, adjust the feet counterclockwise so that they do not touch
the floor, then gently tilt the refrigerator to start moving it.
Door shelf
-
Disassembly: hold both sides of the door shelf with both hands. Push it in from the side
opposite the slot and push it in as shown in the Figure. Push until the edge of the door
shelf separates from the groove in the slide.
-
Assembly: hold the sides of the door shelf with both hands. Install the clip on the slot
first. Then, push the other side slightly inwards–the clip will click into place on the slot
and the door shelf will be installed. Make sure the appliance is installed correctly before
using it. (Fig. 7).
Fig. 7 key:
1. Door-shelf slide
2. Door lining
3. Door shelf
BOLERO COOLMARKET 4D 490 INOX E/ DARK E/ GLASS E
ENGLISH
69

Publicidad

loading

Este manual también es adecuado para:

Bolero coolmarket 4d 490 dark eBolero coolmarket 4d 490 glass e024550245602457