cecotec BOLERO COOLMARKET 4D 490 INOX E Manual De Instrucciones página 77

Some components heat up
Some components heat up after some time of operation of the appliance. This is normal.
Condensation droplets
When outside air enters the cold inner surface of the refrigerator, condensation droplets
may appear. If it's rainy season or humidity at the place of installation is high, condensation
droplets may appear on the outside of the refrigerator. This is a natural phenomenon that
occurs in wet weather. Wipe off the water droplets with a dry cloth.
Noise
- When the refrigerator is switched on for the first time, it will run at high speed to cool
down quickly, and may emit a louder sound. When the internal temperature drops below
a certain level, the noise will decrease.
- When the refrigerator is switched on or off, when various parts expand or contract, when
various control devices are running, or when the temperature inside the refrigerator
changes, you will hear noises. This is normal.
The refrigerator heats up
During operation, the temperature of the condenser is above 80 –do not touch it to avoid
serious injury.
The refrigerator takes a long time to cool down
If room temperature is too high or you put too much fresh food in the refrigerator, it will take
a long time to bring the temperature down to the set values.
See the list below before contacting the official Technical Support Service. The list includes
common occurrences that are not the result of faulty workmanship or materials in this
appliance.
Fault
Nothing showed on
the display
Sounding alarm
Possible causes
The plug of the appliance is not
properly inserted in the socket.
The mains fuse is switched off.
Door is slightly open or has not
been closed for more than 1
minute.
BOLERO COOLMARKET 4D 490 INOX E/ DARK E/ GLASS E
Possible solutions
Correctly connect the plug to the
socket.
Check for power: the fuse must be
connected.
Close the door completely.
ENGLISH
77