Publicidad
Idiomas disponibles
Idiomas disponibles
personnel for operation are necessary due to the high weight. The load attachment points for
lifting gear should be selected as shown in the following figure (indicated by the two arrows).
14
ASSEMBLY
14.1 Checking Scope of Supply
Check the machine immediately after delivery for transport damage and missing parts.
14.2 The workplace
In order to guarantee the operation of the machine, the floor must have sufficient stability and
load-bearing capacity and there must be a free space around the machine of 1500mm for
operation and maintenance.
The selected installation site must ensure a suitable connection to the electrical mains and to a
compressed air supply.
14.3 Assembling the machine
The machine is pre-assembled; only the parts that have been disassembled for transport and the
connection to the supply voltage and compressed air supply as well as to the dust collection
system must be made. Follow the instructions below:
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
电源
POWER
开
关
OFF
ON
急停
EMERGENCY
Edge Banding Machine
Model
HY260B
Panel Thickness
10-50
mm
Edge Thickness
0.4-3
mm
Panel Width
≥80
mm
Power
6.14
Kw
Overall Size
3130×1130×1340 mm
Serial Number
Delivery Date
1. Assembly workpiece plate support
Assemble the workpiece plate support (1)
by means of screws (3) at points A and B
on the guide rods (2) of the machine.
ASSEMBLY
39
KAM215all
Publicidad
