Publicidad
Idiomas disponibles
Idiomas disponibles
16.1.4
Pressure regulator settings for cutter unit edge band / contact pressure
16.1.5
Pressure regulator settings for edge band saw
16.1.6
Setting the milling cut-off
HOLZMANN MASCHINEN GmbH
The set pressure should be between 2-3 bar (0.2 MPa-
0.3 MPa).
Pressure unit (1) is responsible for the adjustment of
the cutter unit, pressure unit (2) for the contact
pressure
To adjust, lift the cap (3) and turn the pressure
regulator in the direction of the arrows to increase
pressure and decrease pressure against the direction of
the arrows.
NOTE:
displayed on the manometer when operated.
The adjusted pressure should be between 3-4 bar
(0,3 MPa-0,4 MPa).
Pressure unit (1) is for setting the end cutting of the
edge band saw unit, pressure unit (2) for the start of the
edge band saw unit.
NOTE:
be slightly higher than that for unit (2).
To adjust, lift the cap (3) and turn the pressure
regulator in the direction of the arrows to reduce
pressure against the direction of the arrows.
NOTE:
displayed when operated.
The amount of material removed from the
workpiece can be adjusted by means of the hand
wheel (1).
The set value is shown on the display (3).
e.g.: 2,0 mm are set, 2 mm are removed at the
edge of the workpiece.
The setting of the milling cutter in clockwise
direction (2) is preset and only needs to be
corrected if steps are milled into the workpiece
NOTE:
same value must also be set on the handwheel (4).
www.holzmann-maschinen.at
The pressure setting for the cutter unit is only
The set pressure for the unit (1) should always
The pressure setting for the unit (1) is only
To obtain the set material removal rate the
OPERATION
43
KAM215all
Publicidad
