16.3.4
Low air-pressure alarm
Check the compressed air supply chain as indicated in the error description.
16.3.5
Error corner trim
1. if the first machining operation has not yet been completed and the workpiece is still moving
into the machining area, the machine stops to prevent the machine from being damaged by the
impact of the workpiece.
2. check the pneumatic cylinder to make sure that it works well.
3. please check the air supply, if it is available in sufficient quantity.
4. please check the magnetic switch, if it works.
5. please check the movement of the cylinder to ensure that it works smoothly.
6. please press the reset switch, after you have removed the workpiece, restart the machine.
17
CLEANING, MAINTENANCE, STORGE, DISPOSAL
17.1 Cleaning
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the machine after each use and remove any sawdust with a brush, broom
•
or vacuum cleaner.
HOLZMANN MASCHINEN GmbH
NOTE
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
51
KAM215all