16.2.4
Edge banding process
16.2.5
Corner trim
16.2.6
Activate emergency stop / switch off the machine.
16.2.7
Fine adjustment of parameters for desired edge result
In order to achieve the desired edge band result, fine adjustments are necessary on the machine,
depending on the edge thickness and the desired shape.
HOLZMANN MASCHINEN GmbH
The corner trim can be activated or deactivated.
NOTE:
deactivated to get an optimal corner/edge result, see
scheme on the left side.
When corner trim is activated, the lower unit is
responsible for corners I and II and the upper one
trims corners III and IV.
In the control module four different types of corners
can be selected.
1. all 4 corners are processed
2. only the two rear corners are machined
3. only the two front corners are machined
4. only the two upper corners are machined
Only in emergency situations:
Stop the machine using one of the two EMERGENCY
STOP buttons (5)
Switch off the machine:
First deactivate/stop all units, then turn the switch
(2) on the control panel to position (O) "OFF" and
turn the main switch (1) to position (0).
www.holzmann-maschinen.at
After the above steps have been carried out,
only the workpiece (3) must be placed against
the guide rail (1) and pushed in the direction
of the conveyor chain (2) with the edge to be
glued facing the machine until it is
automatically transported further by the
conveyor chain (2).
for the first edge(s) the corner trim has to be
OPERATION
48
KAM215all