Publicidad
Idiomas disponibles
Idiomas disponibles
17.2.5
Polishing wheel change
17.3 Storage
Improper storage can damage and destroy important machine parts. Store packed or
unpacked parts only under the intended ambient conditions!
In case of a longer interruption of operation or shutdown, clean the machine and then store it out
of the reach of children in a dry place protected from frost and other weather influences!
17.4 Disposal
Observe the national waste disposal regulations. Never dispose of the machine,
machine components or equipment in residual waste. If necessary, contact your
local authorities for information on the disposal options available. If you buy a new
machine or an equivalent device from your specialist retailer, he is obliged in
certain countries to dispose of your old machine properly.
18
TROUBLESHOOTING
Handling the machine with the power and compressed air supply up can lead to
serious injuries or even death. Always disconnect the machine from the power and
compressed air supply before servicing or maintenance work and secure it against
unintentional or unauthorised reconnection!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to correct the problem!
Trouble
Machine does not start
Glue transfers to rollers
Edge band is not optimally
glued
HOLZMANN MASCHINEN GmbH
Remove the polishing unit from its holder on the
machine by loosening the screw (1). Loosen the
locking tabs of the lock washer (2) on the nut (3)
using a screwdriver. Unscrew the nut (3) and
replace the polishing disc (4). Tighten the nut (3)
again and engage the tabs of the lock washer in
the nut again and mount the polishing unit on the
holder on the machine.
NOTE
WARNING
Possible cause
• Emergency stop switch to
switch off
• switch or a phase is broken
• Overload protection is
triggered.
Too much glue set
•
Less glue set
•
www.holzmann-maschinen.at
TROUBLESHOOTING
Solution
• Turn the emergency OFF switch to
the right to unlock to
• Repair the defective circuit or the
faulty phase
• Wait until the engine cools down
Cover plate close
•
Reduce added glue quantity
•
increase added glue quantity
•
54
KAM215all
Publicidad
