Publicidad
Idiomas disponibles
Idiomas disponibles
Installation, repair, cleaning, and maintenance operations should always be performed
with the equipment disconnected from the power supply.
While the equipment is in operation, it cannot be moved, nor its position corrected. These
operations should always be performed with the machine stopped.
Never use the power cable or the discharge pipe as a means of lifting or supporting the
pump. A suitable rope, wire, or chain, appropriate for the weight, should be attached to the
handle, lever, or hooks provided for this purpose.
The installation's good condition should be periodically checked. If it is not secure, the
equipment should be stopped and repaired. The necessary replacements should be original
manufacturer parts or those recommended by them. The use of other parts from another source,
or original parts rectified by third parties, is not allowed and releases the manufacturer or
distributor from all responsibilities.
If the power cable is damaged, it must be replaced by the manufacturer, its after-sales
service, or similar qualified personnel to avoid danger.
During installation, comply with the electrical installation standards in force in the country
of use.
The installation must comply with the swimming pool installation standard IEC/HD
60364-7-702.
It should be noted that pumps without an indication of whether they are protected against
freezing effects should not be left outdoors in freezing weather.
The pump is not intended for commercial use and must be installed/maintained by
qualified personnel.
The pump is designed to be used attached to a support or while secured in a specific
horizontal position.
The pump cannot be installed in Zone 0 (Z0) or Zone 1 (Z1). Refer to page
DESCRIPCIÓN
Our Pumps have been designed for the recirculation of clean, slightly treated water in private
and commercial swimming pools
Technical characteristics
1.2
Motor:
-
Room temperature: 4ºC a 40ºC.
9
for drawings
Publicidad
