Publicidad
Idiomas disponibles
Idiomas disponibles
-
Service: Continuous.
-
Protection: IPX5.
-
Bearings 2Z: Shielded and greased for life use.
-
Power: (Check pump characteristics plate).
-
Consumption: (Check pump characteristics plate).
-
Voltage: (Check pump characteristics plate).
-
Tension: (Check pump characteristics plate).
-
Efficiency: (Check motor characteristics plate).
-
Nominal RPM: 1.450 or 2.900. (Check motor characteristics plate).
Pump:
-
Pump body: Cast iron (Bronze available on demand).
-
Impeller type: Cast iron (Bronze available on demand).
-
Impeller model: Closed
-
Axes: Stainless steel AISI 316.
-
Mechanical seal: Carbon + resin-ceramics.
-
Liquid density: 1.
-
Liquid temperature: 4ºC a 50ºC.
-
25 meters maximum water column head.
GENERALITIES
3.3 Introduction
This manual contains the necessary instructions for the correct installation, use and
maintenance of the pump. To achieve the maximum efficiency indicated on the pump data
sheet, it is necessary that all recommendations given in this manual must be followed
correctly. This will allow you to work with a safe and durable pump. The manufacturer will
provide the user with any additional information required.
The pump is not intended for commercial use and must be installed/maintained by qualified
personnel.
3.4 Responsibility
All equipment supplied by Fluidra Global Distribution S.L.U. are properly protected to avoid
possible accidents, but in any case all the safety recommendations indicated on the
equipment, documentation supplied and especially all local regulations that apply must be
followed.
It is the exclusive responsibility of the installer/user to evaluate particular risks existing in
each installation and not to allow its connection and start-up without adequate
protections.
TRANSPORT
The manufacturer supplies the quipment protected with the appropriate packaging, so that
when transporting or storing it does not suffer damage that prevents the correct installation
and/or operation.
The user, upon receipt of the equipment, will check the condition of the outer packaging. If it
shows signs of significant deterioration, it will be formally stated to the person who delivers it.
They will also verify the status of the content;
If it presents defects that presumably prevent its correct operation, it will also be formally
Publicidad
