Publicidad
Idiomas disponibles
Idiomas disponibles
USE
10. Switching on – electric
"Before switching on the machine, ensure
the following:
The mains switch is on.
The water mains tap is open".
Turn the master switch (1) to position 1. The indicator light
"machine on" (2) switches on.
If the water level in the boiler is less than the minimum
Turn the master switch (1) to position 2.
The heating element inserted indicator light (3) lights up.
The boiler is heating. Wait until the pressure reading on
the boiler pressure gauge (78) corresponds to the required
working pressure value (1,2 bar).
The machine is now ready to be used.
11. Switching on – gas (only for G machines)
"Do not switch on the gas when the boiler
is under pressure".
Before switching on the machine, check that:
-
The Mains electric switch is on.
-
The water tap is open.
-
The gas tap is open.
Press and rotate the knob of tap towards the left to position
B, and keep pressed for about 30 seconds. Check that
window (23) is open and after a few seconds release knob.
Wait until the initial heating phase has been completed,
i.e. when the
12. Switching-on – dual (gas and electric)
The boiler may be heated by both gas and electricity
simultaneously.
iIn this way the working pressure is reached more rapidly
since the water in the boiler is heated simultaneously by
the electrical heating elements inside the boiler and by the
13. Cup-warmer (where contemplated)
CAUTION: do not put any cloth on the cup-
warmer.
Place only coffee cups, cups and glasses to be used in
conjunction with the coffee machine on the cup-warmer.
78
required operating pressure (approx. 1.2 bar) is indicated
on the manometer (78).
At the end of the working day, switch off the machine by
rotating the general switch (1) to the 0 position and turn of
the gas tap turning it to the "0" position.
To switch on, follow the procedures in Paragraph 1.
Switching on – electric and 2. Switching on – gas.
Ensure that the coffee cups are completely drained before
placing them on the cup-warmer.
No other objects shall be placed on the cup-warmer.
Press the button (6) and check to see that the green light
(5) turns on.
9 EN
1
2
3
Publicidad
