Publicidad
Idiomas disponibles
Idiomas disponibles
17.4 Programming the cappuccino measures
PROGRAMMING THE CAPPUCCINO DISTRIBUTION
KEY (C)
After entering the programming mode, to access the cap-
puccino dosage programming menu, press and hold for
a few seconds the button (30) of the group on which the
cappuccino button is located. A buzzer will start making a
sound that is different from the normal machine program-
ming signal.
"Before programming the cappuccino
with the correct serving of ground coffee.
Don't use coffee grouts for programming
servings."
Plunge the small pipe (18d) into the milk container.
(21) and the cappuccino system (18).
You can now programme the cappuccino push button (C):
1) DISPENSING MILK BEFORE COFFEE
Press the milk distribution key (16) and keep it pressed.
When the quantity of milk in the cup has reached the desired
level, release the key (16): this programs the correct milk
dose.
Once the programming of the milk serving has been com-
pleted, press (and keep momentarily pressed) the cap-
puccino dispensing push button (C) to program the coffee
serving. When the amount of coffee in the cup reaches the
required level, release the push button (C).
18. Cleaning and maintenance
Cleaning the cappuccino maker (where contemplated)
This operation must be made at the end of each working
day.
1) Fill a container with 1/2 litre of cold water and one dose
of liquid detergent (see product instructions).
2) Remove the suction (18d) tube from the milk container
and immerse it in the solution.
3) Press button (16) and repeat the operation until all the
detergent has been used up.
4) Disassemble the cappuccino maker (18):
Unscrew the knob and remove the cappuccino maker
(18).
Remove the cover.
Unscrew the ring nut of the knob (18b) and remove it.
Unscrew and remove the adjustment screw (18a).
Prepare another dose of detergent and clean each
piece.
Remove any residue with a sponge.
21
2) DISPENSING COFFEE BEFORE MILK
Press (and keep momentarily pressed) the cappuccino
dispensing push button (C) to program the coffee serving.
When the amount of coffee in the cup reaches the required
level, release the push button (C).
Once the coffee dose has been programmed, press the
milk distribution key (16) and keep it pressed. When the
quantity of milk in the cup has reached the desired level,
release the key (16)
To exit the cappuccino dosage programming menu, press
the button (30) of the group on which the cappuccino but-
ton is located. The buzzer will make the normal machine
programming sound.
18a
18b
Reassemble the cappuccino maker.
5) Rinse, pumping out at least one litre of cold water.
16 EN
C
30
18
18
18d
16
18d
Publicidad
