Publicidad
Idiomas disponibles
Idiomas disponibles
15.1 Drinks distribution - hot water
After having positioned the appropriate container under
the hot water nozzle (10), distribution is made in two ways.
DOSED FUNCTION
Press one of the hot water distribution keys (13a, 13b or
13c). The corresponding led will light up, hot water will be
issued and will stop automatically upon completion.
The distribution may be interrupted at any time by pressing
the previously active key again (shown by the lighted led).
CONTINUOUS FUNCTION
Press the hot water distribution key (13c) and keep pressed
for approximately 3 seconds.
Hot water will be issued continuously until the hot water
key (13c) is pressed again to stop this function.
In continuous function the progrmmed dosed in the key
is not changed.
15.2 Drinks distribution - steam
Scalding hazard! Use the appropriate
insulating devices (A) to move the water and
steam wands.
Completely immerse the right (9) or left (20) steam nozzle
into the container with the liquid to be heated and push the
steam control lever (11 or 17) upwards.
Wait until the liquid has reached the desired temperature,
then lower the steam command lever to stop the issue of
steam.
Cleaning of steam dispensing pipes
At the conclusion of each steam dispensing
phase:
- Using a clean sponge, wash with hot water
removing any organic residue present. Rinse
carefully.
- clean the inside of the steam nozzle as
follows:
Turn the nozzle towards the cup tray and
carefully activate steam dispensing at least
once.
13a
13b
13c
10
17
20
11 EN
11
9
Publicidad
