Publicidad
Idiomas disponibles
Idiomas disponibles
Reel
Displays the current reel. Adjust the reel number manually by tapping the arrow right. When you
are moving to a new project and want to start from reel '1' again, tap the arrow on the left until
you reach '1'.
Scene
The 'scene' indicator shows the current scene number, and can also show the current shot
number and type. The number on this indicator always refers to the current scene. You can
adjust it with the left and right arrows on either side of the scene number, or tap the scene
number to enter the scene number editor.
Scene numbers range from 1 to 999.
By adding a letter to the scene number in the scene number editor, you can also indicate the
current shot. For example 23A indicates scene twenty three, shot one. If you have a shot letter
added to your scene number, your camera suggests the next scene number and shot letter
whenever you enter the scene number editor. For example, if your current scene number is 7B,
the camera suggests '8' and '7C'.
The scene number indicator can also show information about the current shot type in the top
right corner. You can select these in the scene number editor at the right hand side of the
shot keyboard.
The shot types available are:
When entering 'scene' metadata, HyperDeck Extreme prompts you with scene
number suggestions to the left of the touch keyboard, and shot types to the right
Take
The 'take' indicator shows the take number for the current shot. You can adjust it by tapping the
left or right arrows on either side of the take number, or tapping the indicator to enter the take
number editor.
WS
wide shot
MS
medium shot
MCU
medium close up
CU
close up
BCU
big close up
ECU
extreme close up
Entering Metadata
47
Publicidad
