Publicidad
Idiomas disponibles
Idiomas disponibles
3
Unfasten the standoff mount screw. If you are using a different length NVMe card, unscrew
the standoff mount as well and lightly fasten it into the suitable slot.
4
Peel back the protective blue film on the motherboard heat pad.
5
Remove your NVMe SSD from the packaging and slide the card into place in the PCIe slot.
The slot will pivot up to 30 degrees to help installation.
6
Push the card down lightly onto the standoff mount and fasten the standoff screw. You only
need to tighten enough to keep the NVMe SSD snug.
7
Remove the protective blue film from the heat pad on the inside of the cover plate.
8
Replace the cover plate, the screws will only line up when installed correctly. You will feel a
little pressure on the cover plate from the density of the NVMe SSD combined with the heat
pads. This is normal as it is how they will conduct heat away from the board.
9
Turn the unit right side up and reconnect your power and other cables.
Using the Optional Internal Cache
65
Publicidad
